Numerous publications in a specialized press about warm floors convinced everyone that this is a difficult job that should not be done on your own. However, this is not entirely correct information. If you have sufficient technical skills, it becomes enough to do this work yourself.
First of all, you should decide on the layout of the warm floor. To mark in the diagram in what place the temperature sensors will be installed, where the heating cable will be laid. For example, in places where furniture or plumbing will not be heated, which should not be heated, which means that to save electricity, these zones should be excluded from the general scheme for laying heating cables.
Next, the floor of the floor is carried out, with the purpose of the heat does not go down, through the floor, and it goes strictly upwards. Then proceed directly to the laying of the cable. In this case, the cable is attached using a metal grid, or fixed in a cement screed.
After laying the cable, test tests should be carried out for the presence of the required resistance. If everything is in order, then you can start filling the floor. When installing a thermostat, be careful, since only one error can disable the entire system.
And if you are interested in wholesale trade in building materials, our company TD RNV-Resource offers you its services. We provide a huge selection of building materials in the Far Eastern and Siberian Federal Districts and the Trans -Baikal Territory. From us you can purchase roofing and finishing materials, dry mixes, heat-sound insulation, metal products, paintwork and much more.