Lincruste wall coating was invented more than 100 years ago. Since then, it has been successfully used and popular all over the world. Walls decorated with lininkrust can be found both in the palace and in railway cars. Such popularity is due to several factors. Firstly, Lincruste perfectly holds the relief, and it can be used on non-contested surfaces. Secondly, in order to make wall decoration using this material, you do not need special skills, because it is easy to work with lininkrust. Thirdly, this is an environmentally friendly material made from natural materials.
Linkrust wallpapers are durable, wear -resistant, easy to operate. They can be painted with paint and combined with many natural finishing materials, such as natural stone and wood. The hallways and kitchens trimmed.
Before starting work, it is necessary to clean the surface of the old coating, remove the sockets, and dismantle the skirting board. The wall is spit, grind and primed. After drying, the finishing putty is applied and finally primed. For several days, the surface is dried until completely dry.
Cut the lincust of the desired size and immerse pieces in hot water. After 5-10 minutes they get it and leave for softening for 8-10 hours. Glue lininkrast using perchlorvinyl glue, which is applied to both the wall and the wallpaper. They glue pieces as ordinary wallpapers “joint in the joint”, carefully smoothing, aligning and adjusting according to the figure.
The pasted walls completely dry after 5-7 days. Make sure that the temperature in the room is not below +15 degrees. If desired, after drying, the linkerist can be painted