Before applying the flock, the surface should be well prepared. It is necessary to thoroughly put the walls, and then perform a primer in order to reduce the absorbent properties of the wall (reduce moisture absorption). The surface of the wall should be clean, incorrect and dry, and also have a homogeneous texture. If it is planned to apply a light base layer, then the surface should also be light. In no case should there be fat spots on the wall, otherwise all the work will go. First, the basic gluing layer is applied. For application, you can use a roller with a pile of medium length. It is best that the pile is woolen – this will allow you to apply the base evenly.
The base layer will dry very quickly even at room temperature, so it is recommended that it be slightly lower than the usual level. Immediately after applying the basic adhesive layer to the wall, it is necessary to proceed with the application of the chips themselves. This must be done using a special compressor or flower pistol.
All this equipment can be rented in a store where building materials were purchased. When the applied floral coating dries, it is necessary to slightly draw a brush over the entire surface area in order to remove excess chips. If metallized flocks were used for the decoration, then instead of a brush on the wall you need to go a roller from rubber.
I have my own house in a summer village, which does not have a central sewer. After consulting with specialists, I came to the conclusion that I need to put a septic tank for a summer residence. They explained to me that the installation of a cleaning septic tank will help to cope with the sewage problem, and it does not consume electricity. Thing!